user manual

100. Assemble the MAF element into the new
air box cover with the original screws.
Note the direction of the “FLOW” as
shown on the MAF element-mounting
fl ange, this should point towards the
round opening of the new air box cover.
MAF Element
Air Flow
103. Use a 3/16” drill to make holes in the
locations you marked.
102. Install the air box cover latches by
sliding the base plate into place on the
left (inlet) side of the air box. Push the
base plate up under the upper edge of
the box and against the side of the air
box mount. Note how the left side of the
base plate matches the contour of the air
box. Use a scribe or a pen to mark the
location of the holes in the base plate on
the side of the air box.
101. Here are the new air box cover latch
components. There are components for
(3) latch assemblies.
Base
Plate
Mounting
Screws
Latch
Threaded
Plate
Push Up and Over, Mark Position
9/07
Page 28
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com