user manual

90. Install the new IAT connector harness
onto the Grey and the Gray/Red wires
using the crimp/shrink connectors
supplied. Either white wire can be
connected to the solid Grey and the
Gray/Red wire.
91. Install the crimp/shrink connectors by
stripping a 1/4” of insulation off each
end of the wires. Insert (1) end of the
wire into the crimp shrink connector
and crimp it securely. Using a heat gun
or blow dryer set on high, shrink the
plastic covering of the connector until
the plastic covering completely around
the wire. Crimping the connector alone
is not enough to ensure a permanent
connection; you must shrink the plastic
covering! When you are fi nished cover
the wires and connectors with the piece
of split loom supplied.
89. Tape the (2) short ends of the Gray and
Gray/Red wire at the MAF connector to
the harness as they will no longer be
used. Recover the harness with tape
leaving the SOLID GRAY and the GRAY/
RED wire exposed.
88. Remove the tape on the main branch
of the wiring harness behind the MAF
connector backs to about the #6 fuel
injector branch. Locate the SOLID
GRAY and the GRAY/RED wires
previously cut from the MAF connector
and pull them free from the harness to
this point. You will be making a new
branch on the wiring harness with these
wires.
SOLID GRAY and GRAY/RED Wires
IAT Connector Harness
9/07
Page 25
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com