user manual

85. Locate the Mass Air Flow (MAF)
connector on the wiring harness.
Remove the tape from tape form the
harness back to the main branch.
86. On the MAF connector, locate the
SOLID GRAY wire and the GRAY/RED
wire. This is the Intake Air Temp (IAT)
circuit.
84. Using a “breaker bar” or long 1/2” ratchet
wrench, relieve the tension on the
tensioner arm and install the new drive
belt using the belt diagram provided.
87. Approximately (2) inches behind the
connector cut only the SOLID GRAY and
the GRAY/RED wires.
1/2” Breaker Bar
9/07
Page 24
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com