user manual

80. Remove the tape or shop towels placed
over the port faces. With the help of an
assistant carefully set the supercharger
and manifold assembly in place. Do not
use the black plastic bypass canister as
a lifting point. This is pre-set from the
factory and can be damaged if you lift
with it.
79. Connect (1) end of the 6” length of 1/4”
hose supplied to the small barb located
behind the bypass canister on the
supercharger manifold. Connect the
remaining end of the hose to the FPS
barb located on the fuel rail as shown.
77. Remove the FPS from the fuel rail by
removing the (2) mounting bolts using a
8mm socket wrench.
78. Carefully install the FPS onto the fuel
manifold using a small amount of the
grease supplied on the sensor O-ring.
Fasten the sensor using the (2) original
mounting bolts. Torque the bolts using a
torque wrench and a 8mm socket to 106
in-lbs (12Nm).
Fuel Pressure Sensor
Fuel Pressure Sensor
9/07
Page 22
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com