user manual

67. Remove the throttle body from the intake
manifold by removing the (2) bolts at the
top using a 8mm wrench. Remove the
nuts at the bottom of the throttle body
using a 10mm wrench.
68. With the (2) nuts removed in the last
step, tighten them against each other
“double-nutting” them on each stud.
Remove the (2) studs from the intake
manifold this way.
Mounting Nuts, “Double-Nutted”
65. Here is the tensioner with the stop
removed. Ensure that there is no
material left on the body of the tensioner
where the stop previously was. Grind or
fi le the body to make this area smooth
and fl at with the surrounding area of the
body.
Removed Stop
This area must
be fl at and
smooth.
66. Re-install the modifi ed tensioner into it
original location with its bolts. Torque
the (3) bolts to 22 ft-lbs (30 Nm) using a
10mm socket and torque wrench.
9/07
Page 19
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com