user manual

60. Install the alternator and torque the (2)
mounting bolts to 22 ft-lbs (30 Nm) using
a 12mm socket and torque wrench.
58. Here is the new drive belt idler pulley
and mounting hardware.
59. Install the new bolts through the
bracket and into the holes that originally
mounted the alternator. Note, the gap
between the bracket and the block, this
is where the alternator will mount.
Idler Pulley Mounts Here
57. Install the end of the elbow hose on
to the barb of the new coolant hose
connector with the spring clamp
supplied. Position the connector and
elbow hose so that the elbow hose can
be routed beside the engine. Tighten
the connector hose clamps. Refi ll
the radiator reservoir with the coolant
removed earlier.
Hose Connector Barb
Elbow Hose
Idler Pulley Bolt
Pulley
Spacer
Bracket
Bracket Bolts
9/07
Page 17
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com