user manual

157. Remove the FUSE/RELAY center cover and us-
ing the Magnavolt as a template, drill two 5/16” hole
along the top edge to mount the Magnavolt unit.
158.
Assemble the Magnavolt unit to the Fuse/Relay
center cover by placing the rubber mounts into the two
holes in the cover and then place the magnavolt on the
rubber mounts. Secure the mounts with the nuts sup-
plied and tighten them with a 10mm wrench.
159. Connect the Black ground (-) wire of the Mag-
navolt harness onto the chassis ground connection lo-
cated just below the Cruise Control module platform.
Remove the nut with a 10mm wrench and place the
ring terminal on the stud. Re-install the nut and tighten
it securely.
Chassis
ground
160. Connect the Red positive (+) wire with the ring
terminal to the main power connection on the side of
the Fuse/Relay Center. Remove the nut with a 10mm
wrench and place the ring terminal on the stud by
passing the red wire up from under the base and on to
the stud. Re-install the nut and tighten it securely.
12/05
Page 42
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com