User Manual

Adjusting the Center Column
1
To raise or lower the center column, loosen
the center column locking collar by rotating it
counterclockwise. (Fig. H)
2
Position the center column at the desired height,
and tighten the locking collar by rotating it
clockwise. (Fig. I)
Using the Suction Cup
1
Start with the tripod legs collapsed but in
spread position.
2
Loosen the center column locking collar, and push
the center column downward until the suction cup
adheres to the surface. (Fig. J)
3
Tighten the center column locking collar.
Note: For an enhanced grip, slightly moisten the bottom
of the suction cup.
Extending the Tripod Legs
1
Spread the tripod legs.
2
Rotate the twist locks a quarter turn
counterclockwise to loosen them. (Fig. A)
3
Pull out the legs to their full extension. (Fig. B)
4
Rotate the twist locks clockwise until secure.
Collapsing the Tripod Leg Extensions
1
Rotate the twist locks a quarter turn
counterclockwise to loosen them. (Fig. C)
2
Give each leg a firm push to fully collapse it. (Fig. D)
3
Rotate the twist locks clockwise until secure.
4
Fold the legs in.
Using the Three-Way Pan Head
• To use the 90˚ tilting feature, loosen the tilt lock by
twisting it counterclockwise. Position the head at the
desired angle, and tighten the tilt lock by rotating it
clockwise. (Fig. E)
• To use the 360˚ panning feature, loosen the pan
locking knob. Pan as necessary, and tighten the
locking knob. (Fig. F)
• To change the camera orientation from horizontal
to vertical position, loosen the platform locking
knob. Rotate the platform 90˚, and tighten the
locking knob. (Fig. G)
Figure A
Figure H
Figure J
Figure G
Figure F
Figure E
Figure C
Figure B
Figure I
Figure D