Owner`s manual
MAGNUM ZC FIREI'LACE INSTALLATION INSTIW CTION
1) Move the fireplace into place.
2) Install the outside air assembly.
3) Inslall the floor protector. R
ef
er to the section Ilcarth Extension Requirements and make sure the gap
between the fireplace and the hearth extension is
sealed (refer to page 15).
OUTSIDE AlIl
lN
S TALLATJON (oillio
na
l)
If an Outside Air Kit is to be installed observe the guidelines given in the section on Outside Air Kit
Requirements. Make a 4
Yo"
(110 rum) hole in the outside wall of the house at the chosen location. From
outside, place the outside air register in the hole
(open side down) and fasten the register 10 the wall with screws
as shown (SEE FIGURE 22). At each end, carefully pull back the insulation and the plastic cover exposing the
flexible duct. Place the flexible duct over the register tube
and over the fireplaces outside air connector 4" elbow
located inside the bottom of the fireplace (
SEE
FIGURE 23).
Using aluminum tape,
wrap the joint between the flexible duct and the air inlets. Carefully push the insulation
and on the outside register (SEE FIGURE 22) pull the plastic cover back over the duel. Using aluminum tape,
fasten the plastic
cover in place. Only the insulation will go into the fireplace area on the unit side.
OUTSIDE AIR INTAKE REGISTER
,'IGUIU: 11
OlJfS
lD
E AIR CONNECTOR IN UNIT
FI(
;UR
F,
23
Mllpluml C
....i1.
4 ~
dho
wlot/Iud
undc' lhe unil.
Open t
lK:
Io..n
~.
I 1
pi
ll 10
IIC«U
.
I I '.
"'~
P1
Mtie
...-.
co,'a
t:
-"
l
F1
e' iblc duet
Aluminum
l.o.po:
IMUllllion Ind pl
,"
'ie _ ,
O
PF.N
r
tfo'
DO
WN
M
AG
NUMl C MANUAL_ No
.e
mber 2009 PAGE · •
27