Owner`s manual

of Top PM eI
of I.cfl l'anel
of " and Drill
of Yo " NUl Driv er
(36) II 81ck screws
of (op liOlIIl I)
1I1II Ilmer lind 16
penny nails
of Righi Panel
T eo ls need ed:
7.C· 7S Mesh Kit
1.IC l1 l1l t 5:
Top
Panel
Overall Il l.
48.500 in.
Up""
Grill
Angle Iron
frame
loward
!lange of
unit
Mesh ("cinll
upward
Ri
ght Sidc
Pa nel
I Lower Grill I
Left Side
Panel
/o. 'XP A NIJ /o:IJ " "' HTd ' . FAC E KIl ' I NSTALLAT IO N
(I'O R S TON I . ~ BRI CK ,e 711. 1-: I 'ACIN C. ') M l' ~h Kit (ZC·7S)
I" Overall width44.250 in.
Damper =1
Handle
Wood
SlUd s
Mesh facing
upward
Angle Iron
frametoward
Ilange ofunil
OUl line of
sides and Illp
orunit
behind zc,
15 M C!i h Kit
... H:U1U: 13
I) Take the mesh kil and hardware nut o fthe packaging and make sure llull all items arc included . Comact your su pplier
if any parts
arc missing.
2) Align the left & right panels so t hatt he mesh openings are facing upwards and the angle iron is close to the front r.1CC
plate
of the unlt, Do nol burt the angle iron tight aga inst the facc plate. Leave II 5 111a 1l1l 1l1011 llt of expens fon room
(1116" is nornllll).
J) Fasten the mesh in place using fhe self dr illing and tapping screws provided. S crews every 8 ,10 inches apart is
sufficient. Do
not tighten the screws tight on the face of the unit. Le ave expension mo m for the mesh to move ( 1 /32 "
is sufficient).
4) Eit her wood screws or nails (not provided) can be used to fasten the mesh 10 the wood stud s Oil the lell nod right sides
oCthe
unit (these shon 1 11 he tight).
5) Follow the sallie procedure for the lop panel,
6) Make sure tha tthe grill opening is aligned parralel and straight wilh the unit.
WAI{NING: We t" glm·f!.f II'l'ell IWlltllillg / instalting tI,e M e ~II Kit. The ('tl/:e.((Ire Jllnrp II
M A(j NIJM/ .c MANlJAL - No~mbn 2009 r .... m, ,.
21