Owner`s manual

Gl ASS & GASKET R Hl' U CH MI iNT
To remove the glass, take the d oor off of the fmme by opening the door and lifting the cas t iron door up ofT of the
hinges. Make S Ure that the door is cool before laking orr or the unit. Move the door back and forth as you lift.
The hinge pins arc snug. La y the door 011 8 n ew sp aper or cloth 10 keep the sool and dirt from gelling on the floor.
Next. using a
Phillips #2 screwdriver. loosen the fO llr-(4) screws that hold the clips in place. ( SEE FIGURE 4)
Make sure not
10 bind the screwdriver against the glass. Remove the glass thn! is broken and clean the area that
the glass sits in. The replacement glass
will have new gaskcting installed from the factory. Make sure thai all of
the old gasketing is removed from thedoor.
Carefully place the new glass in the door channel and replace the clips that hold the glass in place. When
installing the screws make sure
thut thc clips nrc tightened evenly. 1> 0 not tlghtcn the screws on onc end and then
the other.
The clips should put even pressure against the glnss so it will not move but is 1I 0t binding. When you
tighten the scre ws, remember
that thcy nrc easily stripped lind should only be tightened enough to hold the clips
firmly . Make sure that you do not bind the screwdriver again stthe gI IlSS . Finally, be careful uot to drop the cast
frame as you align
it with the hinges and slip it into place.
G1A .\·S C.A RE e REPLACf:MBN T
Th e glass used for the MAC : NUM 'I. e: doors is a high temperature ceramic glass. (f the glass breaks, it must be
replaced with factory replaccm cnt ceramic glass (SEE FIGURE 5 FOR DIMENSIONS). Tempered or ordinary
glass will not withstand the high temperatures
of the MAG NUM 'I.e. Replacement glass should be purchased
from you r dealer or the factory. Do not operate the unit with cracked or broken glass .
CLl I' (4)
t"IC;U1U: 4
10·24 SCREW
GASKET
COMES
INSTALLED
ON
G1J\SS
16 Yo "
HG Ult F. ~
II
/ /
/ I /
I. 1O ~ . _,
T
I ] 'Yo"
MAGNUM/ .C MANIlA L ~ ~mbn J OO9
1' 11. 01, • •
"