Owner's Manual
USE
Riding instructions
NOTE
The battery must be secured and locked into the frame before riding.
Before riding, be sure that the battery is correctly inserted into the frame and remove the key. If left in place the key
can break in case of impact.
WARNING - FALL HAZARD!
To avoid injury be sure to follow the instructions below:
1. Before starting to ride, hold the handlebars (1) straight.
2. To start practicing, start with the motor switched off. Only switch on the motor when you are comfortable riding the bike.
3. Do not use the pedals (2) to start until a safe riding position is assumed.
4. When starting to ride, apply the brakes slightly. This inhibits the motor and enables a safe start to your ride.
The bicycle can be driven with the auxiliary drive switched on or without it.
When the auxiliary drive is activated, the electric motor is activated immediately upon pedaling with a half pedal rotation.
On long uphill runs, the motor could potentially become so hot that the current is reduced by the temperature sensor in the motor. The internal heat
sensor may cut out the electrical system of the e-bike if it overheats.
If the e-bike cuts out let the system rest for a few minutes and resume riding while being sure to pedal in order to alleviate the stress on the electrical
system.
Range per charge
The achievable range with a charge of the battery depends on a variety of factors. These include the battery and vehicle condition, the total load and
above all the route elevation. Under normal conditions, the Li Ion battery has a range of approximately 50 miles per charge.
Please remember:
● Before each major ride, recharge the battery and check the tire pressure.
● The battery develops its max power after approximately five discharge / charge cycles.
● The battery is subject to normal self-discharge over a long period of time.
16










