Owner's Manual

Removing the battery
To pull out the battery, insert and turn the key. Hold the key in the unlock position and then pull out battery (1).
Inserting the battery
- To reinsert the battery push the bottom of the battery (1) into the frame as far as it will go and then insert the top end of the battery into
the frame until it clicks in place. You may then remove the key.
Battery charge status
The charge state can also be checked with the battery removed.
- While the button (1) is pressed, the LED (2) will light up depending on the charge state:
green 4
The battery is fully charged.
green 3
The battery is about 3/4 charged.
green 2
The battery is about 2/4 charged.
green 1
The battery is almost empty, you should
charge it soon (about 1/4 residual capacity).
red
The battery is empty.
Tire pressure
To avoid flats, keep tire pressure at the recommended PSI. On off-road terrain a slightly lower PSI will provide more grip but flats can occur.
WARNING
Caution should be exercised when inflating tires with compressor air pressure equipment (eg gas stations). Due to the relatively
small volume of air required be sure not to overinflate the tires as this can cause them to burst.
Correct tire pressure should be adjusted according to the terrain within the range of. 26 to 54 psi.
15