Specifications

LIGHT TOWER START UP
Before starting the light tower, carefully read the pre-start check list. Make sure that all of the items are checked
before trying to start the light tower. This check list applies for both manual and remote starting.
PRE- START CHECK LIST
 Make sure the control ON/OFF toggle switch is in the OFF “O” position.
 Make sure that the circuit breakers (main and convenience) are switched OFF “O”.
 Check that the light tower is properly grounded to a good earthen ground per any local and NEC
regulations.
 Check all electrical connections at the connection lugs. Are they wired correctly?
 Are the connection lugs tight?
 Check that the voltage selector switch is set to the desired voltage.
 Is the voltage selector switch locked?
 Is the light tower sitting level?
 Check for any water inside, on, or near the unit. Dry the unit before starting.
 Check oil, coolant and fuel levels and engine battery connections.
 Check engine fan belt tension and condition.
 Check engine fan belt guard.
 Check engine exhaust system for loose or rusted components.
 Check radiator and surrounding shroud for debris.
 Are any of the generator covers loose or missing?
 Are all preventative maintenance procedures up to date?
 Check that the battery disconnect switch is on, if equipped.
MANUAL STARTING OF THE LIGHT TOWER
1. Move the control ON/OFF toggle switch to the “CONTROL ON / I” position.
2. The Liquid Crystal Display (LCD) window will quickly display system information, all Light Emitting
Diodes (LED’s) will flash.
3. The LCD window will indicate MANUAL mode and Ready. The Ready/Manual LED will be lit. Note: The
unit must be in the “MAN” Mode with the Ready/Manual LED lit to start the unit.
28