Specifications

7
10
13
4
2
2
1
3
6
9
12
5
8
11
MAIN CONTROL PANEL COMPONENTS
1. MAIN CIRCUIT BREAKER (90A): This breaker will disconnect power to the connection lugs.
2. LUG DOOR SAFETY SWITCHES: These switches will shut the generator down if the lug door is opened when the
generator is running.
3. GENERATOR OUTPUT CONNECTION LUGS: These allow appropriate loads to be wired directly to the generator.
4. GENERATOR GROUND CONNECTION LUG: This lug is for connecting a good earthen ground per any local, state
or National Electric Code (NEC) guidelines before starting the generator.
5. REMOTE START TERMINAL BLOCK: Allows connections for remote starting of the generator.
6. CABLE ACCESS: Allows for entry of load cables to the connection lugs with the lug box door closed.
7. PHASE SELECTOR SWITCH: This switch will change the generator output between three phase and single phase
power. See the VOLTAGE SELECTOR SWITCH section for more information.
8. VOLTAGE ADJUSTMENT RHEOSTAT: Used to fine tune generator output voltage.
9. CONTROL POWER SWITCH: This is the main power switch for the controller in MANUAL or AUTO mode.
10. ENGINE CONTROL PANEL: See pages 12 - 13 for additional information.
11. BALLAST INDICATOR LIGHTS: Indicates power from the ballast to each light.
12. INDIVIDUAL CIRCUIT BREAKERS: One breaker is supplied for each light.
13. AUXILIARY OUTLET MAIN CIRCUIT BREAKER (100A): This breaker disconnects power to the auxiliary equip-
ment outlets.
11