Owner's Manual

5mm

4mm

1. Open the top cover, align the stem with the head

tube and slide it on. Tighten the screw at the top of

the stem.

2. Align the handlebar to be perpendicular to the

wheel, then insert and tighten the two side-facing

screws as shown below.

5mm

Screw for adjusting the

handlebar position

3. Move the handlebar up or down to adjust to the

desired angle, then tighten the rear-facing screw at

the top of the stem to lock the handlebar in place.

4. Close the cover to complete installation and

adjustment.

2.Installation and Adjustment

2.1 Handlebar and Stem Assembly

Installation & Adjustment