Operation Manual

Disturbances, failure signals and/or wrong readout of information:
1. Return to Start menu:
in main-screen press the Menu button, select other functions and confirm, select Reset All and
confirm again.
Select language …..the first question of the Start menu will appear in the display and proceed.
2. Switch the current off/on and try again.
3. Switch off the power, remove the thermostat and check if all wiring is connected correctly.
4. If none of the above mentioned correct the problem contact your supplier or installer.
Installation instructions for mounting the ME-Control:
Press the housing of the display slightly together at the sides and use a pencil or something similar,
not sharp object, and press it carefully into the square hole on the upside of the thermostat. Both,
housing and base-plate, can now be removed
Ensure that the power supply is switched off. Connect the wires to the thermostat as per the
instructions.
Locate the ME-Control thermostat into the back box (deep single switch back box) and secure in place
with two screws.
Replace the base-plate and display housing and push into place.