Owner's Manual

2
Throttle error(detection after turning on)
3
motor without phase position
4 Hall error
5 Brake error(detection after turning on)
6 Under voltage
7 Motor stalling
8 communication controller receiving error
9 communication display receiving error
4.3 SET OPEARATION
Hold the SET for 2 seconds and enter into the setting interface, then number 0 keeps
lighting, the display will flash at 1 HZ. Click the SET to switch from 0 to 4 circularly to
set interface, click UP or DOWN to select the needed para- meter, and press the SET 
for 1 second will exit the setting interface.
4.3.1 SET 0: Riding mode selection
There are three modes for selection: POWER, NORMAL and ECO. 4.3.2 SET 1: 
Reset trip 1 distance
Click the DOWN to reset the trip 1, then the TRIP 1 icon will flash at 1HZ, meanwhile 
the trip 1 will be cleared.