Specifications

1. ENGINE STARTING BATTERY

2. PUMP OUTLET (DISCHARGE) PORT. Opening for discharge of liquids from the pump. Fittings can be threaded

or bolted to the pump flange.

3. REAR LEVELING JACKS. Used to level the rear of the pump on rough or uneven ground.

4. CHECK VALVE. A valve that permits flow in one direction only. (Required for pump priming.)

5. DRAIN/SUCTION HOSE RELEASE VALVE. (Located on rear skid.) Allows for complete draining of the pump

volute for storage and/or maintenance. This valve can also be opened to relieve pressure on the rear suction

hose to facilitate removal of the hose.

6. PUMP INLET (SUCTION) PORT. Opening for intake of liquids into the pump. Fittings can be threaded or bolted

to the pump flange.

7. REAR HOOD PRIMARY LATCH. See page 12 for hood operating information.

8. FLOODED SUCTION BYPASS VALVE. This valve is used to prevent water from back flowing into the compressor

when there is a flooded suction. The valve should remain open for normal pump operation. (Pictured in open

position.)

9. PUMP VOLUTE (HOUSING). Cast-iron housing for pump mechanical components.

10. ANTI-SHUT LATCH. See page 12 for hood operating information.

11. CENTRAL LIFT EYE. Used for lifting the pump.

12. FRONT HOOD. See page 11 for hood operating information.

13. FRONT HOOD LATCH. See page 11 for hood operating information.

14. FRONT LEVELING JACK. Used to level the pump on rough or uneven ground and to aid in attaching the pump

to a tow vehicle.

15. ENGINE COOLANT DRAIN

16. ENGINE OIL FILL

17. AIR CLEANER ASSEMBLY

18. REAR HOOD. See page 12 for hood operating information.

19. REAR HOOD SECONDARY LATCH. See page 12 for hood operating information.

20. CONTROL PANEL. Controls and indicators for pump operation.

21. MANUAL HOLDER. Storage for operator manuals.

22. ENGINE OIL DRAIN

23. FUEL FILL PORT. Lockable port for filling the fuel tank with clean DIESEL fuel.

24. HAND THROTTLE. Controls pump engine speed.

25. COOLANT OVERFLOW BOTTLE

Note: Use hoses and fittings that are specifically designed and sized for this type of equipment.