User Manual

IVx3 Injection Valve Manual
Rev. 03/2012 Page | 29
Valve Testing:
After an IVX3 has been serviced, MVP recommends that it should be fully tested before
it is used in production.
The following items are required to test the valve:
 8018 – IVX3 SERVICE MODULE (shown below)
 Soapy water
We recommend that during a service the actuator assembly is first tested prior to fitting
the fluid section.
NOTE: See the IVX3 Service Module manual for more detailed instructions on its
use for testing the IVX3.
IVX3 SERVICE MODULE (8018)