User Manual

Classic Pro Gun Manual

Rev. 08/2012 Page | 33

Gun Handle Rebuild:

Remove Chopper Elbow Assembly

1. If the elbow fitting has not already been removed, do the following procedures:

A. Use a wrench to loosen the pipe seal on the elbow assembly.

B. Unscrew the elbow assembly by hand.

Male Elbow 7701-6-18 is used on Gelcoaters and saturtars with special valving.

Pipe Plug 09990 is used on Hydrajectors, Saturators and Casting units without special vavling.

Note: This elbow assembly is used to supply air to the chopper. The gel coater

gun’s elbow assembly has different part numbers and also includes a plug. If

ordering replacement parts, please make sure you use the correct parts drawing.

Remove Trigger Assembly

1. Remove trigger locking hairpin.

2. Remove the fillister-head screw (F-FS-540-08) on the side of the gun-head.

3. Pull the trigger retainer and spool assembly from the gun handle interior.