Manualshelf

Owner's manual

ManualsBrandsMagnum Venus Plastech ManualsEquipmentCHOP CHECK FLUID CCPLS-1000
21222324252627282930
CCPLS-1000 Fluid Section Manual
Rev. 08/2012 Page | 26
Stainless Steel Intake Valve Assembly –
1. Apply a light film of the proper lubrication to the inside of the Intake Valve
(CCPLS-1017-SS).
2. Lightly grease and install Lower Intake Valve Seal (CCPLS-1015) into the Intake
Valve (CCPLS-1017-SS).
3. Apply a drop of Loctite to the threads of the Intake Valve Packing Nut (CCPLS-
1016-SS) and thread it just a little ways into the Intake Valve (CCPLS-1017-SS).
4. Take the Intake Valve (CCPLS-1017-SS) assembly and install it onto the Priming
Rod (CCPLS-1027-SS), with the Intake Valve Packing Nut going on first.
5. Finish tightening the Intake Valve Packing Nut (CCPLS-1016-SS) into the Intake
Valve (CCPLS-1031). Slide it up against the Valve Stop (CCPLS-1014).
SEAL – CCPLS-1015
INTAKE VALVE PACKING NUT – CCPLS-1016-SS
INTAKE VALVE BODY – CCPLS-1017-SS