Owner's manual

Step 4) Push the DOWN CURSOR button and the display will change to this:

Step 5) Push the DOWN CURSOR button and the display will change to this:

Step 6) Push the DOWN CURSOR button and the display will change to this:

This is the decimal point setting for the display in the RUN mode. It is

initially set at the factory to +- 0.10 pounds. If you desire more accuracy,

push the RIGHT CURSOR button until you achieve the decimal point

location you desire.

NOTE: When changing the decimal point setting it is also necessary to

change the calibration number (Step 7) by a corresponding factor.

Step 7) Push the DOWN CURSOR button and the display will change to this:

This is the calibration number for a HVLS-1000 High Volume Resin Pump

dispensing resin with a specific gravity of 1.08 and is preset by MVP. This

value is intended to be used with a one place decimal display and is

accurate to +- 0.10 pounds. See Chart B for calibration numbers for other

specific gravities and the VLS-4600 pump.