Owner manual

Advantage Gelcoater

ADVANTAGE Gelcoater

Shutdown

Chapter

Short-Term Shutdown

Drain Moisture Filter

Drain moisture filter by holding a small, empty container under the filter

and turning the filter valve beneath the filter until water drains out (See

Figure 32).

NOTE

Cleaning the gun head is required if you are stopping

production or there will be long pauses in operations

for lunch, part cure or any reason.

CAUTION

Always wear approved eye protection when working

near pressurized equipment.

NOTE

This section discusses short-term shutdown. Follow

these procedures whenever the gun will be idle for at

least the standard gel time of your materials. If the gun

will be idle for longer than one week, perform Long-Term

Shutdown.