Owner manual

Advantage Gelcoater

CAUTION

After filling the catalyst jug, reinstall cap on jug. Other-

wise, catalyst may be contaminated.

Figure 9: Fill Catalyst Jug

Place the gelcoat resin container in position on or near the Advantage

Gelcoater. You need at least 2 gallons (7.5 liters) of gelcoat resin to

begin operations.

Be sure you have enough solvent to fill the flush tank at least half full (at

least 1-1/2 gallons). Do not fill the flush tank yet; this procedure is de-

scribed later in this manual.

Check Hoses

Check hoses for abrasions, kinks, and cuts.

CAUTION

If the gelcoat resin runs out during operation, the pump

will runaway and damage may occur.

NOTE

Runaway/The speed of the pump increases immedi-

ately and damage to the pumping system can occur.