Manual

19
PISTOL ASSEMBLY AFTER CLEANING.
1. Put the barrel in the slide and turn it so that the barrel
lug is overhead inside the ejector port.
2. Do not press the trigger, before you put on the slide.
(It could be turned the pin and the slide could not
be put in. In this case you have to put slide onto the
guide without spring and pin compare in the guide).
3. Put recoil spring on the frame. Hold slide with barrel in
right hand and put it on the guide in the frame as long
as the assembly line and point were in lining - up.
Then turn barrel about 180º to the left as the barrel is
locked in the frame and pistol is assembled.
CAUTION:
NO FUTHER DISASSMEBLY IS NEEDED! If you assume that
pistol is damaged, give it to a competent gunsmith.
CLEANING THE PISTOL
Clean the pistol :
• each time you use it
• if you get your pistol wet
• as soon as possible after shooting
• at least twice a year in a mild climate
• as often as once a month in a humid climate
CLEANING THE BARREL BORE AND THE
CARTRIDGE CHAMBER
If the pistol has not been fi red or if only a few cartridges
have been fi red, clean the barrel bore and cartridge chamber
by the clean patch attached to the cleaning rod. Repeat
the cleaning, changing patches until the last patch comes out
clean.
When the barrel bore is very dirty apply a pistol cleaning
solution using a cleaning brush. Let the solvent act for about
10 minutes / this time depending on the solvent agent
being used. Then thoroughly scrub out the barrel bore.
Subsequently, dry the barrel bore and cartridge chamber
with a clean patch and check that all powder residues
or fouling have been removed. If necessary repeat this
procedure. The cleaning rod and the brush must be inserted
into the barrel bore from the chamber, to prevent wear or
damage to the muzzle. pass the brush all the way through
the barrel bore before reversing the movement. If you try
to change directions with the brush in the barrel the brush
could stick.