Instruction Manual

5. Loading and unloading the pistol
A. Loading the pistol
- Activate the safety and decock the pistol (see chap. 2)
- Open the barrel sleeve. To do this, press the release lever down lightly and let it slide to the open position (illustration 7).
During this process, keep the pistol in a horizontal position to prevent the pellet clip from falling.
- Remove the pellet clip and load the Diabolo .177 (4.5mm) caliber pellets, top down, in each hole (illustration 8).
- To prevent function errors, ensure that the base of each pellet ends in the pellet clip or it is slightly buried in the hole.
- Place the pellet clip in the pistol (illustration 9) and close the barrel sleeve. To do this, hold it on the top and push it
until it fits into place (illustration 10). During this process, the release lever should be in a horizontal position.
Illustr. 7
Illustr. 8
front
bottom
wrong
right
Illustr. 9
wrong
Do not use steel pellets (or BBs), darts or other unsuitable ammunition. Use only
.177 caliber (4.5 mm) pellets with a maximum length of 6.5 mm
WARNING:
Do not place your hand or fingers over the muzzle. Always make sure your air pistol
is pointing in a SAFE DIRECTION, and keep your finger away from the trigger. Failure to follow these
warnings may cause serious injury or death.
WARNING: