Instruction Manual

To clean the outside, use a soft cloth.
Your air pistol will work best if you put just a drop of oil directly on the tip of the CO
2
cartridge before inserting.
DO NOT use a petroleum distillate based oil or solvent and DO NOT over-oil as this can cause damage to your
air pistol. Occasionally apply between 2 and 3 drops of oil for air guns to the following pieces:
Slide guides, hammer rod, trigger pin.
Tampering with the air pistol or attempts to modify the air pistol in any way may make it unsafe to use and will void
the warranty. If you drop your air pistol, check to see that it works properly before you use it again.
If your air pistol is damaged or does not perform properly, call Umarex USA Customer Service for assistance
before using your air pistol again.
9. Storage
Always store the air gun with the ammunition removed and the safety on. Carefully check that there is no ammunition in
the barrel and remove the pellets from the pellet clip. Before storing it, we recommend to also remove the CO2 cartridges.
Keep the air gun out of the reach of children and users not familiarized with its use. Store the air gun separately from
the pellets and the CO
2 cartridges.
Never leave the air gun loaded.
WARNING:
10. Care and Maintenance
If you maintain and care for your air pistol properly, you will be able to enjoy it for many years.
Before you attempt to clean your air pistol, always make sure it is "On Safe"
(see Step 3.1), the pellet clip is removed and you have checked the barrel to make sure there are
no pellets left in it.
WARNING: