Instruction Manual

Set up of additional rail
To install the additional Weaver rail, attach it to the lower part of the grip
using the two screws provided. Ensure that the rounded part of the rail is
pointing toward trigger (illustration 14).
8. Adjusting the sight
Aim at a secure target: Hold the weapon so that the rear sight is lined up with
the front sight at the same time. The front sight should be exactly in the center
of the notch of the rear sight. Next raise the gun so that the lower part of the
target central round meets the front sight. The upper part of the lower sight, the
upper part of the front sight and the lower part of the target should be in line
(illustration 13). The impact point of pellets can be adjusted by means of the
lateral adjustment screw in the rear sight. The pistol is adjusted by the factory
to shoot from a distance of 11 yards (10 m).
Adjusting the standard sight system
To laterally adjust the standard sight system, it is necessary to move the rear sight.
To do this, loosen the rear sight screw located on the top (illustration 11).
- For shots to head to the right: adjust the rear sight to the left.
- For shots to head to the left: adjust the rear sight to the right.
Finally, retighten the rear sight screw.
Illustr. 11
Illustr. 12
Illustr. 13
too high too low right
Illustr. 14