Operator`s manual

Viewing Waveforms, Vectors, and Pictures
7-23
To change clamp speed:
1. Press the Config button.
2. Select INPUT and then press the Enter button.
3. Select CLAMP and then press the Enter button or turn the knob to change between SLOW and
FAST.
4. Press Clr Mnu to exit.
Viewing a Picture with Waveforms
Most waveform montors do not let you view a picture. The MM-410/AVM-510A not only lets you
view a picture, but also shows you a safe title area and lets you view a waveform, vector, and picture
all at the same time (Figure 7-24). As a result, you are able to monitor the signal parameters you select
to make sure they stay within the tolerances you set.
Figure 7-24. Safe Title Area
If you want to see a picture of the signal at any time, push the Picture button. Push the Picture
button a second time to see the picture overlaid with what you were previoulsy looking at. If you push
the Vector button twice and then push the Picture button twice, you will see the picture overlaid
with the vector and the waveform. This works with a waveform alone, a vector alone, and with the
AVM-510A AUTOMEASURE screen.
The Split Screen button brings up another way to see the picture with the waveform and vector.
Press the Split Screen button once and you will see the waveform and vector in one-quarter normal
size positioned at the bottom of the picture (see Figure 7-25).