Operator`s manual

Operating the MM410/AVM-510A
6-7
SET INTERNAL CLOCK
Lets you set the internal clock of the MM-410/AVM-510A. The selections are: YEAR, MONTH, DAY,
HOURS, and MINUTES, and SECONDS. Select Press To Set and then the Enter button to save the
internal clock settings.
SYSTEM IDS
Lets you display the MM-410/AVM-510A system software and hardware identification information
for: Loader, Software, Fnt Pnl, Hardware, and Board ID.
MEMORIES Sub-Menu
This section describes each of the MEMORIES sub-menu options.
STORE MEMORY
Lets you store up to 10 separate waveform, vector, or picture setup configurations. Select STORE
MEMORY, turn the knob to select the memory number, and then press the Enter button to store the
settings in memory.
IMAGE NUMBER
Lets you Recall, Store, and Delete up to 6 separate waveform, vector, or picture memory locations.
Select RECALL, STORE, or DELETE and then press the Enter button to confirm.
IMAGE DENSITY
Lets you see and set the image density of a display in the form of a horizontal bar graph.
REFERENCE
Lets you select between an internal (INT) or external (EXT) signal reference for synchronization.
PICT. REFERENCE
Lets you select an internal (INT) or external (EXT) signal reference (REF) when any picture is
displayed. Note that if you select the REF option, the signal reference will be the same as what was
selected in the REFERENCE menu option.