Operator`s manual

Operating the MM-410/AVM-510A
6-6
PRINTER SETUP
Lets you select and display the following options:
PRINTER TYPE − Display the type of printer connected to a computer (HP DeskJet 500C, HP Laser
Jet, HP DeskJet, or Epson FX-85.
PRINT DENSITY − Lets you see the print density of a display in the form of a horizontal bar graph.
BAUD RATE − Lets you select a baud rate for data transfers between the AVM-510A and a computer.
Available baud rates: 9600, 19,200, 28,880, 38,400, 57,600, and 115,200.
HANDSHAKING − If a computer is connected to your AVM-510A, you can select either the
handshake protocol XON/XOFF or HARDWARE. Otherwise, select NONE.
COMPUTER SETUP
Lets you select and display the following options:
BAUD RATE − Lets you select a baud rate for data transfers between the AVM-510A and a computer.
Available baud rates: 9600, 19,200, 28,880, 38,400, 57,600, and 115,200.
HANDSHAKING − If a computer is connected to your AVM-510A, you can select the handshake
protocol XON/XOFF. Otherwise, select NONE.
Press Enter To Print Waveform
Lets you print a waveform when a waveform is selected and the Enter button is pressed.
ALARM SETTINGS (AVM-510A)
MASTER ALARM (ON or OFF)
ON (enables) or OFF (disables) the alarm output on pin 1 of the DC CONTROL/ALARM connector.
MASTER ALARM DELAY
Controls the response delay of the alarm [0 (OFF) to 5 minutes].
CC ALARM DELAY
Controls the response delay of the CC alarm [0 (OFF) to 10 minutes].