Operator`s manual

6-1
6
6. Operating the MM-410/AVM-510A
Introduction
This chapter describes how to operate the MM-410 Waveform/Vector Rasterizing Monitor (MM-410)
and the AVM-510A Series Automated Video Monitors (AVM-510A). By now you should have the
MM-410/AVM-510A installed and configured for your specific needs. Using the information
provided in this chapter, you can now select, monitor, automeasure, and report the appropriate display
options available in the Config (Configure) and Mesmnt (Measurement) menus.
This chapter also describes how to:
•
Use intensity and persistence
•
Controlling the AVM-510A with a computer
•
Identify waveforms
•
Display SC/H phase and time codes
•
Getting information to and from the AVM-510A
•
Print waveforms and vectors (AVM-510A):
– Intensity, persistence, and print density controls
•
Videotape waveforms
•
Memory recall with external switches
•
External alarm and memory status