Operator`s manual

4-1

4. Installation

Introduction

This chapter describes how to install the MM-410 Waveform/Vector Rasterizing Monitor (MM-410)

and the AVM-510A Series Automated Video Monitors (AVM-510A) and into a rack, how to connect

cables to them, and how to configure them for your specific needs.

Installing the MM-410/AVM-510A into a Rack

The MM-410/AVM-510A mounts into any industry-standard rack. To install either one:

1. Install the rack ears onto the MM-410/AVM-510A.

2. Insert the MM-410/AVM-510A into the rack and then secure it using the supplied screws.

Connect the supplied power cord to an ac power source and to the back of the MM-410/AVM-

510A.

CAUTION: The MM-410/AVM-510A produces very little heat and does not

need a lot of air space. However, installing it in between two devices that

produce a high amount of heat might cause overheating.

For optimal performance, keep the top cover airflow unrestricted.