Operator`s manual

Product Overview (AVM-510A)
3-6
AVM-510A Rear View
The following cable connectors can be viewed from the rear of the AVM-510A (see Figure 3-2).
Legend Connector Function
1
RS-232 computer
interface
A bi-directional communication interface that lets you control the
AVM-510A by way of ASCII control codes.
2
Picture monitor
outputs
These outputs (S-video and composite) are available for a picture
monitor display of a picture, waveforms, or signal status.
3
Analog Audio
inputs
Provides a fixed amplitude input through a 9-pin D-sub connector.
4
Composite (A) One switchable loop-through composite input.
5
Composite (B),
CPST or G/Y
One switchable loop-through composite, CPST, or G/Y component
input.
6
CNPT (B) One switchable loop-through B/B-Y component input.
7
CNPT (B) One switchable loop-through R/R-Y component input.
8
Power Line voltage power connector (ac input).
9
RS-232 modem
interface
A bi-directional communication interface to modem that lets you
control the AVM-510A over a standard telephone line.
:
DC control/ alarm
DC Control − Lets you select any of the first four memories by
grounding (earthing) pins 1 through 4.
Alarm − When enabled, after an alarm delay, this open collector output
(pin 5) goes to ground (earth) indicating an out-of-tolerance condition.
Refer to Chapter 4, “Installation,” for additional information on this
connector.
;
External Reference A composite analog external reference signal representing studio
reference timing.
<
S-video
(A or B)
One switchable loop-through S-video input. Can only be selected
using the Input menu options.
ALARM
RS232
COMPUTER
MODEM
OUTPUTS
EXT REF
S-VIDEO (A or B)
COMPOSITE (A)
VIDEO INPUTS
MAGNI SYSTEMS INC., USA
AVM-002
11
12
POWER
DC CONTROL
S-VIDEO
CPST
PICTURE MONITOR
ANALOG AUDIO
INPUTS
COMPOSITE (B)
CPNT (B)
CPST or G/Y B/B-Y R/R-Y
4
5
6 7
2
1
3
8
9
10
Figure 3-2. AVM-510A Rear View