Operator`s manual

Command Codes (AVM-510A)
E-7
H8 m bit0 color frame display on
m bit1 VITC time code on
m bit2 graticule off
m bit3 PAL graticule in percent
H9 m bit0 LED reduced size WFM
m bit1 LED reduced size VEC
m bit2 system in 625 line mode
m bit3 measurement set 2 active
H POS NOTIFY ‘H’N . .N<CR> N. .N = [0. .999]
Response to H POS REQUEST. This is a
normalized position, that is, a value of 500
would put the slider in the middle of the
range. 0 is all the way to the left; 999 is all
the way to the right.
V POS NOTIFY ‘V’N . .N<CR> N. .N = [0. .999]
Response to V POS REQUEST. This is a
normalized position, that is, a value of 500
would put the slider in the middle of the
range. 0 is all the way to the bottom; 999 is
all the way to the top.
VECTOR PHASE
NOTIFY
‘P’N . .N<CR> N. .N = [0. .999]
This is a normalized position, that is, a value
of 500 would put the slider in the middle of
the range.
VAR GAIN NOTIFY ‘G’N. .N<CR> N. .N = [0. .255]
Response to VAR GAIN REQUEST.
0 = least gain
255 = most gain
SELECTED LINE
NOTIFY
‘L’S. .S<CR> Response to SELECTED LINE REQUEST.
MEASURE LINE
NOTIFY
‘N’S. .S<CR> Response to MEASURE LINE REQUEST.