Operator`s manual

Memory Locations
C-2
When a configuration is saved in a memory location, all MM-410/AVM-510A functions are
stored in that memory. This includes items that are not displayed. For example, a waveform and
measurement setup when a picture is displayed. For best results, recall a memory location,
make a modification, and then store the new settings in another memory location.
To recall any stored memory at any time, press the Blue (2nd) button and then one of the Memory
Recall buttons (for memories 1 through 10).
NOTE:
You can also recall the first four memory locations through the ground closures of
the DC CONTROL/ALARM connector. (see Figures 2-2 and 3-2).
Refer to Chapter 6, “Operating the MM-410/AVM-510A,” for more information about
using the Config menu to save memory locations.
MM-410/AVM-510A Memory Locations
Memory Input/Format Description Other Items
1 A Composite Waveform, two line display
2 A Composite Picture with save title marks
3 A Composite Waveform and vector overlayed
4 A Composite Vector display
5 A Composite Automeasure, system video measurement set Waveform only in MM-410
6 A Composite Split screen of picture inset with waveform and
vector
7 A Composite Split screen of picture inset with waveform and
vector
8 A Composite Waveform
9 A Composite Automeasure, non linear measurement set Waveform only in MM-410
10 A Composite Waveform
All settings are saved under each memory location.