Operator`s manual

B-1

B. Connector Pinouts

Introduction

This appendix identifies and describes the connector pinouts at the rear panel of the MM-410

Waveform/Vector Rasterizing Monitor (MM-410) and the AVM-510A Series Automated Video

Monitors (AVM-510A).

NOTE:

Connector pinouts are viewed from the outside of the MM-410/AVM-510A rear

panel and/or viewed from the wire side of the furnished connectors.

Video Input/Output Connector (4-Contact mini DIN)

Pin Number Description

1 Ground

2 Ground

3 Y (composite) in/out

4 C in/out

Figure B-1. Video Input/Out Pin Locations