Operator`s manual
A-1
A
A. Specifications
Introduction
This appendix lists the the MM-410 Waveform/Vector Rasterizing Monitor (MM-410) and the AVM-
510A Series Automated Video Monitors (AVM-510A) electrical and mechanical specifications.
Electrical
Video Standards
•
NTSC and PAL Composite plus S-video
•
EBU, SMPTE, Beta, and MII Component (525/625)
Inputs
NOTE:
All MM-410/AVM-510A input connectors are located at the rear panel unless
otherwise noted.
Video Inputs
•
Two loop through inputs (Input A: and Input B:)
– Input A:, configurable for Composite or S-video
– Input B:, configurable for 3-wire Component, S-video, or Composite
NOTE:
The single S-video input can be assigned to Input A:, Input B:, or left inactive
•
Composite, S-video, and component loop through inputs:
Description Specification
Return loss (75 Ω)
> 40 dB to 6 MHz
Maximum operating input
voltage
+/– 2.5 V (dc + peak ac)
Input level before clipping +/– 0.98 V dc relative to blanking level
Audio Inputs (AVM-510A)
•
Four analog balanced inputs (> 15 k Ω impedance, 9 pin D-sub)
External Reference Input
•
Composite loop through (NTSC/PAL)