Manualshelf

Operator`s manual

ManualsBrandsMagni ManualsComputer equipmentAVM-510A
141142143144145146147148149150
AVM-510A-C (For Component Measurements)
12-2
•
75% COLOR BARS forces the AVM-510A-C to recognize the signal as 75% color bars (see
Figure 12-1).
•
100% COLOR BARS the AVM-510A-C assumes the signal is 100% color bars.
6. Press the down Arrow button to highlight xxx LIMITS, where xxx is the component system
currently configured for Input B:.
7. Press the Entr button to continue.
Figure 12-1. Setting Limits for Component Signals
8. Use the Arrow buttons to move the cursor up and down to the desired parameter.
9. Press the Entr button to move the cursor to the MIN column. Turn the knob to set the minimum
acceptable value.
10. Press the Entr button to move the cursor to the MAX column. Turn the knob to set the maximum
acceptable value.
NOTE:
When in the MIN and MAX columns, the Arrow buttons switch the cursor back
and forth between the two columns. The Entr button moves from MIN to MAX , or from
MAX out and down to the next parameter name. At this point, you are back to step 8. The
Prev Mnu button moves the cursor to the parameter in the current row.
11. Press the Clr Mnu button to exit or press the Prev Mnu button twice to go back and pick another
measurement set.