User's Manual

3
64
Indicators and warning lights
Warning lights on the display
Inertia switch, fuel cut- out enabled
This switches on when a
collision triggers the inertia switch, thus cutting off the fuel supply.
After impact, if fuel is smelt or leakage is noted from the fuel system, do not reactivate the
switch in order to help prevent the risk of fire.
Windshield washer fluid This signals a low level of washer fluid in the
windscreen washer tank.
Cruise Control This indicates that the constant speed regulator,
Cruise Control is active.
Lights failure This switches on in the case of a system failure or burning-
out of the bulbs for the position, direction indicators or rear fog lights.
License plate lights failure This switches on in the case of
a system failure or burning-out of the number plate lights bulb.
Stop lights failure This switches on in the case of a system failure or burning-
out of the stop lights bulb.
Twilight sensor failure This switches on in the case of a failure of the twilight
sensor.
Too high catalytic converter temperature This warning light starts
flashing or comes on permanently when engine failure results in high exhaust system temperature.
IF THE WARNING LIGHT IS FLASHING: the catalytic converters' temperature is too
high. Slow down immediately until the warning light goes out.
IF THE WARNING LIGHT TURNS ON PERMANENTLY: the catalytic converter
temperature is at a dangerous level and the catalytic converters themselves may be damaged. Slow down immediately until it turns off, and slowly drive to the nearest service centre. WARNING: If the light turns on permanently 3 times the engine will stop. Will be possible to restart only by key- off - key-on and recarsi lentamente in officina.
Maserati declines all responsibility for whatever damage deriving from non
compliance with the above mentioned warnings.