User's Manual

▷ Switch the mobile phone off and on again.
▷ Too high or low ambient temperatures? Do
not subject the mobile phone to extreme
ambient conditions.
Telephone functions not possible.
▷ Configure mobile phone and connect with
the telephone or additional telephone func‐
tion.
No phone book entries, not all entries or incom‐
plete entries are displayed.
▷ Transfer of the phone book entries has not
completed.
▷ Under certain circumstances only the phone
book entries saved in the mobile phone or
on the SIM card are transferred.
▷ It might be that phone book entries with spe‐
cial characters cannot be displayed.
▷ Number of phone book entries to be stored
is too high.
▷ Data volume of the contact too large, for ex‐
ample due to stored information such as
notes? Reduce data volume of the contact.
▷ Mobile phone connected as audio source?
Configure mobile phone and connect with
the telephone or additional telephone func‐
tion.
Quality of the phone connection is poor.
▷ Bluetooth signal strength can be adjusted
on mobile phone, depends on the model.
▷ Place the mobile phone in the snap-in
adapter or close to the centre console.
▷ Adjust the volume of the microphone and
speaker separately.
If all the points on the list have been reviewed
and the desired function cannot be run, contact
Hotline or Service Centre.
Controls
Adjusting the volume
Turn the volume knob on the radio until the de‐
sired volume is reached. The setting is saved for
the remote control currently in use.
Automatic volume equalisation
The vehicle adjusts the volume of the micro‐
phone on the telephone and the volume of the
other party automatically. Depending on the
mobile phone, it may be necessary to adapt the
volumes. Settings are possible only during a call
and must be adjusted separately for each mobile
phone. The settings are deleted as soon as the
mobile phone is de-registered.
1.
"Settings"
2. "Sound"
3. "Volume settings"
4. Select desired setting: "Microphone" or
"Loudspeak."
5. Adjusting: turn the controller.
6. Saving: press the controller.
Incoming call
Receiving a call
If the number of the caller is saved in the tele‐
phone book and is transferred from the network,
the name of the contact and the telephone num‐
ber is displayed. Otherwise, only the phone
number is displayed.
Accepting a call
Using iDrive
"Accept"
Seite 82
Communication Telephone
82
Online Edition for Part no. 01 40 2 917 877 - II/13