Technical information

Enrange MLTX2 Transmitter Instruction Manual
March 2014
Page 36 of 48
WARNING
ALWAYS REMEMBER TO STORE THE PASSWORD IN A SECURE LOCATION FOR ACCESS IF THE
PASSWORD IS LOST OR FORGOTTEN. ONCE THE TRANSMITTER IS PROGRAMMED WITH A
PASSWORD, THERE IS NO WAY TO DEFEAT THE PASSWORD WITHOUT USING THE RCP
SOFTWARE TO EITHER READ THE PASSWORD OR REPROGRAM A NEW PASSWORD.
WARNING
THIS PASSWORD FUNCTION IS NOT TO BE USED AS A SECURITY DEVICE. THE PURPOSE OF THIS
FUNCTION IS TO PREVENT ACCIDENTAL CHANGES TO THE TRANSMITTER SETTINGS. THE BEST
FORM OF SECURITY IS ALWAYS TO LOCK UP THE TRANSMITTER WHEN NOT IN SERVICE.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT.
The password default setting is to be disabled during initial programming by the RCP software.
To enable password protection, check the box next to the phase “Activate password.”
WARNING
NOT ENABLING THE PASSWORD FUNCTION ALLOWS THE TRANSMITTER SETTINGS TO BE
MODIFIED BY ANY UNAUTHORIZED USERS. IMPROPER TRANSMITTER SETTINGS COULD RESULT
IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
Backlight Enable
This section allows the user to enable the LCD display backlight (on systems equipped with
optional graphic user interface LCD display) and select the period of time after transmitter activity
that the backlight stays on.
The user has the option to check the “Always On” check boxed for backlight timeout. If this box
is checked, the backlight will remain on continuously while the transmitter is active.
NOTE: The longer the backlight is turned on, the shorter the transmitter battery life will be.
The user can also enable the backlight to turn off or timeout after a period of time, the user can
select the custom field and enter in the time (in seconds) that the backlight should be lit. The
range of values is 1 to 30 seconds.