User`s manual

Page 10
52134 867
FUNCTION
LED 1LED 2LED 3LED 4
2. Push Button Functions with LED Displays
A. Standard Push Button Configuration (Transmitter Toggle)
Set transmitter toggle (latching output relay) function by adjusting the 8-position function
dip-switch located on the backside of the transmitter encoder board (refer to Fig. 09 below). The
LED 1 through LED 4 shown inside the shaded box (see below) illustrates which LED on the
transmitter will light up when the designated push button (PB-5 ~ PB-8) is pressed.
(Fig. 09)
DIP PB-5 PB-6 PB-7 PB-8
1
00000000 Normal Normal Normal Normal
2
00000101 Normal Normal Normal LED 4
3
00000110 Normal Normal LED 3 LED 4
4
00000111 Normal LED 2 LED 3 LED 4
5
00001000 LED 1 LED 2 LED 3 LED 4
* PB-5…PB-8 → Push button number
* Normal → Normal momentary contact
* LED 1…LED 4 → Transmitter toggled with designated LED Display