Technical information

Enrange XLTX Intrinsically Safe
Transmitter Instruction Manual
April 2014
Page 9 of 24
2.5 PRE-OPERATION TEST
At the start of each work shift, or when a new operator takes control of the equipment, operators should do,
as a minimum, the following steps before making lifts with any equipment:
Test all warning devices.
Test all direction and speed controls.
Test the transmitter emergency stop.
2.6 HANDLING BATTERIES
WARNING
KNOW AND FOLLOW PROPER BATTERY HANDLING, CHARGING AND DISPOSAL PROCEDURES.
IMPROPER BATTERY PROCEDURES CAN CAUSE BATTERIES TO EXPLODE OR DO OTHER
SERIOUS DAMAGE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR
DEATH AND DAMAGE TO EQUIPMENT.
Use only batteries approved by Magnetek for the specific product.
Do not dispose of a battery pack in fire; it may explode.
Do not attempt to open the battery pack.
Do not short circuit the battery.
Do not use sharp tools to remove the battery pack or the cells.
Keep the battery pack environment cool during storage (i.e., not in direct sunlight or close to a heating
source).
2.7 BATTERY DISPOSAL
Before disposing of batteries consult local and governmental regulatory requirements for proper disposal
procedure.