Technical information

Enrange XLTX Intrinsically Safe
Transmitter Instruction Manual
April 2014
Page 18 of 24
4.0 TRANSMITTER SETUP
The built-in dip switch block can adjust the RF channel. All other settings can only be changed
at the factory.
4.1 TRANSMITTER SETUP SETTINGS WITH STANDARD STATUS LEDS
WARNING
TO PREVENT IGNITION OF FLAMMABLE OR COMBUSTIBLE ATMOSPHERES, AND TO AVOID
COMPROMISING INTRINSIC SAFETY OF THE EQUIPMENT, READ, UNDERSTAND, AND ADHERE TO
THE LIVE MAINTENANCE PROCEDURES BELOW.
The only setting that can be adjusted via the dip switch block is the RF channel setting. This dip
switch block is visible through the IR window (see Figure 7).
Figure 7: Dip Switch Block as viewed through IR port
NOTE: The dip switch block switches are oriented so that the Off position is next to the number
designator and the On position is up or away from the number designator.
Regardless of which radio frequency the transmitter was equipped with, the RF channel dip
switch settings are the same. Refer to Sections 5.2 and 5.3 for details on the specific RF
channel details for the radio frequency that the transmitter is equipped with.