Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 7 of 33
 Leave any load unattended while lifted
 Leave power on the radio controlled equipment when the equipment is not in operation
 Operate any material handling equipment using a damaged controller because the unit may be
unsafe
 Operate manual motions with other than manual power
 Operate radio controlled equipment when low battery indicator is on
WARNING
THE OPERATOR SHOULD NOT ATTEMPT TO REPAIR ANY RADIO CONTROLLER. IF ANY PRODUCT
PERFORMANCE OR SAFETY CONCERNS ARE OBSERVED, THE EQUIPMENT SHOULD
IMMEDIATELY BE TAKEN OUT OF SERVICE AND BE REPORTED TO THE SUPERVISOR. DAMAGED
AND INOPERABLE RADIO CONTROLLER EQUIPMENT SHOULD BE RETURNED TO MAGNETEK FOR
EVALUATION AND REPAIR. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS
INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
WARNING
TO AVOID ELECTROSTATIC DISCHARGE THAT COULD DAMAGE THE PRODUCT, THE OPERATOR
SHOULD AVOID CONTACT WITH THE RECEIVER ANTENNA PORT.
2.4 PRE-OPERATION TEST
At the start of each work shift, or when a new operator takes control of the crane, operators should do, as a
minimum, the following steps before making lifts with any crane or hoist:
Test all warning devices.
Test all direction and speed controls.
Test the receiver emergency stop.