Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 32 of 33
CAN messages
are not being
received by the
receiver
The CAN message being
sent is not supported
Use the supported messages OR contact
your supplier to inquire about a software
update.
Termination resistor has an
incorrect value
Verify that the setting of the terminating
resistor is correct for the application.
Incorrect baud rate
Ensure the correct baud rate is set by all
devices on the bus.
CAN messages
transmitted by
the receiver are
not being
received
Incorrect source address
Make sure that the source address of the
receiver is set correctly.
The termination resistor is
set incorrectly
Ensure the termination resistor is
appropriately set.
Incorrect baud rate
Ensure the correct baud rate is set by all
devices on the bus.
Outputs not
functioning
Faulty Wiring
Check all wires for loose or damaged
connections.
Output is shorted or opened
Check all wires and connections for
damaged insulation.
7.2 ASSEMBLY AND REPLACEMENT PARTS
If your receiver ever needs repair, we always recommend that you have Magnetek perform the
repair. If you need to refer to a parts list, refer to your receiver’s drawing that was included in the
shipment of your receiver. Please contact Magnetek’s service department at 1.866.MAG.SERV
for information regarding parts and service.