Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 24 of 33
RF Antenna
This section allows the user to select between using the internal antenna that is built into the
receiver or using the external antenna attachment (if available).
NOTE: Selecting the external antenna when one isn’t available will result in reduced RF
performance.
Rx Timeout
The Rx Timeout is the amount of time the unit will keep the machine stop outputs closed after the
receiver has stopped receiving data from the transmitter.
Device Name
The device name field allows the user to create a custom name for the unit. The name can be up
to 16 ASCII characters long.
Project ID
This section displays the Project ID for the unit. The Project ID is set by the factory and cannot
be modified by the user.
Serial Number
This section displays the serial number for the unit. The serial number of the unit is set by the
factory and cannot be modified by the user.
Pin Properties Grid
By clicking on one of the CAN functions in the Device Block Diagram, the Pin Properties Grid will
permit the user to change the configuration of the CAN interfaces.
Source Address
This is the address that the CAN-2 will use as the source address when transmitting messages
on the CAN-bus network.
Baud Rate
This pull-down menu allows the user to modify the communication speed of the CAN bus
network. The user selectable options are 50k, 125k, 250k, and 500k.