Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 23 of 33
Unit Info Properties
Frequency
This field displays the operating frequency band of the receiver. The receiver Radio Frequency is
set by the factory and cannot be modified by the user.
Access Code
The access code acts as the receiver address. The receiver will only listen to transmitters with
the same access code. This feature is selectable by the user.
NOTE: The transmitter must be set with the same access code as the receiver to properly
communicate with each other.
WARNING
THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE
THESE ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING RECEIVER AND ITS ACCESS
CODE. CHANGING THIS CODE COULD MAKE IT COMMON WITH ANOTHER RECEIVER ACCESS
CODE, WHICH COULD MOVE OTHER EQUIPMENT. NO TWO SYSTEMS IN ANY LOCATION SHOULD
EVER HAVE THE SAME ACCESS CODES INDEPENDENT OF FREQUENCY. FAILURE TO FOLLOW
THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.
RF Channel
The RF channel is user selectable through the pull down menu. This function is used to prevent
interference with other radio devices. Refer to Section 6 for information about the selectable
channels for each frequency band.